CG Blacklight Topped with Powerlock

Discussion in 'Last Steps: Waxes, Sealants, and Coatings' started by JC98, Jul 7, 2011.

  1. JC98

    JC98 Birth of a Detailer

    Has anyone done this yet? Just curious about durability. Still not sure if blacklight is a glaze or sealant. Would topping with the powerlock be a waste of time or not.

    Any help or insight is appreciated.
     
    JC98, Jul 7, 2011
    #1
  2. Kilo6_one

    Kilo6_one DB Forum Supporter

    I dont see why it would not work........even though they claim its an LSP, I think without some sort of sealing it lasts very short. Even with V7. I had better luck with Zaino spray seal over BL then V7.
     
    Kilo6_one, Jul 7, 2011
    #2
  3. mrgolfrider

    mrgolfrider DB Forum Supporter

    I am currently testing durability on my wife's ford fusion it's only been about 2 months but it's garage kept also

    Sent from my HTC Vision using Tapatalk
     
    mrgolfrider, Jul 7, 2011
    #3
  4. Chaseme

    Chaseme DB Forum Supporter

    I thought BL was a finishing polish (with sealant properties).
     
    Chaseme, Jul 7, 2011
    #4
  5. JC98

    JC98 Birth of a Detailer

    It's listed as a glaze on the CG site.

    How is it holding up? Do you think topping with powerlock took away from the BL finish?

    I am definitely over analyzing this combo lol...
     
    JC98, Jul 7, 2011
    #5

Share This Page